Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

AP Scanner Installation

We on working on moving from a hotsport architecture to a 95%+ wireless coverage in our campus buildings.  I had wireless survey completed which shows me where i should place my APs to achieve the desired coverage.  We hace a WISM and WCS system and would like to increase our visibility of our wireless network by installation APs in scanner mode.  The question I have is what is the ratio of scanner APs per production AP, or what is the best installation scenario, 1 or two per floor.  I am unable to location any best practices.  We plan on installating AIR-CAP3502is.

Thanks

Mike

1 REPLY
Hall of Fame Super Gold

Re: AP Scanner Installation

Deploy and activate your APs.  Any excess APs that give out too much signal then convert it to "monitor" mode.

200
Views
0
Helpful
1
Replies
CreatePlease login to create content