Welcome to Cisco Support Community. We would love to have your feedback.
For an introduction to the new site, click here. And see here for current known issues.
upgrade to the latest firmware.
want to setup ap1200 as a dhcp server for wireless client. but it seems there something wrong with setup. client cannot get IP address from AP. please take a look my configuration
no service pad
service timestamps debug datetime msec
service timestamps log datetime msec
enable secret xxx.
username admin password xxx
ip dhcp pool xxxpool3
network 192.168.105.72 255.255.255.248
no ip address
no ip route-cache
ssid XXX WLAN
speed basic-1.0 basic-2.0 basic-5.5 basic-11.0
rts threshold 2312
bridge-group 1 subscriber-loop-control
bridge-group 1 block-unknown-source
no bridge-group 1 source-learning
no bridge-group 1 unicast-flooding
bridge-group 1 spanning-disabled
ip address 192.168.105.69 255.255.255.192
ip default-gateway 192.168.105.65
ip http server
ip http help-path http://www.cisco.com/warp/public/779/smbiz/prodconfig/help/eag/ivory/1100
bridge 1 route ip
line con 0
line vty 0 4
line vty 5 15