Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

AP1220B and WLC 4400

Will Aironet AP1220B (AIR-AP1220B-A-K9) compatible with WLC4400 with an IOS upgrade? I looked up on notes and docs but couldn't figure out if that particular model is supported to run under Wireless LAN Controller. Or I just have to do an upgrade to another model?

Upgrading Autonomous Cisco Aironet Access Points to Lightweight Mode

http://www.cisco.com/en/US/products/hw/wireless/ps430/prod_technical_reference09186a00804fc3dc.html

Lightweight Access Point FAQ

http://www.cisco.com/en/US/products/ps6306/products_qanda_item09186a00806a4da3.shtml

1 ACCEPTED SOLUTION

Accepted Solutions
Hall of Fame Super Red

Re: AP1220B and WLC 4400

Hi Zwe,

You are going to need to upgrade to a different model :( Have a look;

For all Cisco IOS Software-based Aironet 1200 Series modular AP (1200/1220 Cisco IOS Software upgrade, 1210, and 1230 AP) platforms, the ability to convert the AP depends on the radio.

If the radio is IEEE 802.11g, MP21G and MP31G are supported.

If the radio is IEEE 802.11a, RM21A and RM22A are supported.

You can upgrade the 1200 Series APs with any combination of supported radios:

G only

A only

Both G and A

From this doc;

http://www.cisco.com/en/US/products/ps6306/products_qanda_item09186a00806a4da3.shtml

EOS/EOL for Cisco Aironet 802.11B-Based and First Gen. 802.11A-Based Prods

http://www.cisco.com/en/US/products/hw/wireless/ps430/prod_eol_notice0900aecd802ad911.html

Hope this helps!

Rob

2 REPLIES
Hall of Fame Super Red

Re: AP1220B and WLC 4400

Hi Zwe,

You are going to need to upgrade to a different model :( Have a look;

For all Cisco IOS Software-based Aironet 1200 Series modular AP (1200/1220 Cisco IOS Software upgrade, 1210, and 1230 AP) platforms, the ability to convert the AP depends on the radio.

If the radio is IEEE 802.11g, MP21G and MP31G are supported.

If the radio is IEEE 802.11a, RM21A and RM22A are supported.

You can upgrade the 1200 Series APs with any combination of supported radios:

G only

A only

Both G and A

From this doc;

http://www.cisco.com/en/US/products/ps6306/products_qanda_item09186a00806a4da3.shtml

EOS/EOL for Cisco Aironet 802.11B-Based and First Gen. 802.11A-Based Prods

http://www.cisco.com/en/US/products/hw/wireless/ps430/prod_eol_notice0900aecd802ad911.html

Hope this helps!

Rob

Community Member

Re: AP1220B and WLC 4400

Hi Rob,

Thanks for the reply. I guess I only have a choice of either replacing B with G/A card on all those models or getting a whole new unit with all new technologies.

Have a good one.

Zwe

379
Views
0
Helpful
2
Replies
CreatePlease to create content