Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

AP1252 + Common Industrial Protocol + Rockwell

Hello,

I want your help. I have an network with automation Rockwell. I have an access point 1252 in workgroup Bridge in automation and an access point 1252 in access point mode.

I must to send since automation:

     - Multicast

     - UDP

     - CIP (Common Industrial Protocol (CIP™))

How can an 1252 accept theses 3 parameters ?

Best Regards,

Nicolas LEFEBVRE

1 REPLY
Hall of Fame Super Gold

Re: AP1252 + Common Industrial Protocol + Rockwell

The AP doesn't care what you are using. It will send and receive any valid Ethernet frame.

248
Views
0
Helpful
1
Replies