Re: AP1262 can't get IP address and can't join WLC
Was the cable tested? The reason I ask is that we're you able to connect that other AP to the same cable or did you just connect it to the switch? No matter what, you will need to take that ap down. If it's a cable issue, then fix the cable. If you can put another AP using the same cable and it works, then I would delete the images from the AP and upload a new rcv image to the 1262. You can try it using the cable, but then you have to get into ROMMON mode in which you need to hit esc when the AP is booting up.
Transferring Crash file from standby:
Login to the Active WLC in HA.
(Cisco Controller) >transfer upload datatype crash
(Cisco Controller) >transfer upload filename <Desired filename>
(Cisco Controller) >transfer up...
This is the start of a display filter cross reference between Wireshark and OmniPeek.
The 1st installment is a table of advanced filters. More filters will be added as time allows.
It is a living doc, so check back for changes every so often
Please feel ...
I have created a Powershell script to automatically add a Wireless Guest User on Cisco WLCs. (tested on 2500 Series)
The script should be completely self explanatory.
Powershell SNMP Module (Install-Module -Name SNMP)
SNMP Write Access to...