Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

Anonymous
N/A

Application Visibility Control and QoS on Foreign controller

 

Is application visibility control working on a foreign and anchor environment?  I couldn't get foreign controller show AVC information.  Foreign controller has 7.4.121 and FUS 1.9.0.

Will bandwidth rate limit in QoS work on a foreign and anchor environment?

 

Thanks,

2 REPLIES
VIP Purple

HiIn Foreign/Anchor setup,

Hi

In Foreign/Anchor setup, you can see AVC info from Anchor controller as all L3 traffic anchored to that controller.

Here is what  AVC deployment guide states about it

"In the case of Anchor and Foreign controller’s configuration, the AVC has to be configured where the application control essentially is required. In most cases in Anchor/Foreign setups the AVC should be enabled on the Anchor controller. AVC profile enforcement will happen on the WLAN on the Anchor controller. If Anchor controller is release 7.4 or higher the above mentioned setup will work"

 

Refer this post as well since it discuss a topic relevant to your query as well

https://supportforums.cisco.com/discussion/12043756/qos-ssid-using-anchor-controller

 

HTH

Rasika

**** Pls rate all useful responses ****

Anonymous
N/A

Rasika,Am I going to have

Rasika,

Am I going to have same issue for QoS setting on the foreign controller?  Can I configure QoS on the foreign controller?

Thanks,

123
Views
0
Helpful
2
Replies