Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Community Member

APs' Telnet interface

Here's a silly one, but it's been bugging me for a while:

How do you gracefully exit out of a telnet session to an AP? i've been killing the connection via my emulator, but if I'm into the AP through a router, I have to re-establish the connection with the router.

The manuals don't give any consideration to closing out the telnet session.

Any help is appreciated.

1 REPLY
Community Member

Re: APs' Telnet interface

You need to enter the close command in the command line mode by prefixing it with a colon. You can view this and other commands by accessing the help.

:CLOSE Close the telnet session if the connection is open

Regards

Kev

154
Views
0
Helpful
1
Replies
CreatePlease to create content