07-27-2010 02:57 AM - edited 07-03-2021 07:01 PM
Hi,
Is it possible to configure an ASA context in routed mode and another Context in transperent mode ?
Solved! Go to Solution.
07-27-2010 07:03 AM
Hello,
Good question!
From the Command reference for 8.3 for the 'firewall transparent' command:
http://www.cisco.com/en/US/partner/docs/security/asa/asa83/command/reference/ef.html#wp2016768
The quote is the same in the 8.0 and 8.2 command references.
"
Usage Guideline
For multiple context mode, you can use only one firewall mode for all contexts. You must set the mode in the system configuration. This command also appears in each context configuration for informational purposes only; you cannot enter this command in a context.
"
So, unfortunately, it looks like the answer is no. Hope this answers your question!
-Joe
07-27-2010 07:03 AM
Hello,
Good question!
From the Command reference for 8.3 for the 'firewall transparent' command:
http://www.cisco.com/en/US/partner/docs/security/asa/asa83/command/reference/ef.html#wp2016768
The quote is the same in the 8.0 and 8.2 command references.
"
Usage Guideline
For multiple context mode, you can use only one firewall mode for all contexts. You must set the mode in the system configuration. This command also appears in each context configuration for informational purposes only; you cannot enter this command in a context.
"
So, unfortunately, it looks like the answer is no. Hope this answers your question!
-Joe
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: