[ASK] Is it possible using more than 32 APs using H-REAP???
I've got some questions here on my head. I read that H-REAP only support 3 APs and should be only deployed on remote site.
Here is my case, my client have 2 building as HQ. Let's say Building A and Building B. Datacenter is located in Building A and all users there using wired network. In Building B, users are supposed to use wireless network (about 8 floor and 3 APs each floor). The network architecture in Building B is flat (all layer 2 using different vlan each department on building B). WLC will be located in Building A.
And I think it's ridiculous to have all local conversation traversing all the way to Building A and back to users in Building B. Is it possible to configure H-REAP for all APs in building B???
Transferring Crash file from standby: Login to the Active WLC in HA.
From CLI: (Cisco Controller) >transfer upload datatype crash (Cisco
Controller) >transfer upload filename (Cisco
Controller) >transfer upload mode tftp (Cisco Controller) >transfer
This is the start of a display filter cross reference between Wireshark
and OmniPeek. The 1st installment is a table of advanced filters. More
filters will be added as time allows. It is a living doc, so check back
for changes every so often Please feel f...