Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Community Member

associate only with one access point

Gentlemen,

I have WLC with 3 accesspoints, all them are shown in wlc and their status enable and REG, my problem is the users can associate only with one access point but they can't associate to the others ???

* Note :

in GUI - Security - AP Policies - authorized AP - there is only ONE I added the other 2 later but the same results.

Any idea ASAP,

Thanks

2 REPLIES

Re: associate only with one access point

so your 3 access pooint are asociated corectly if they show the REG estatus, now check the security parameters in the WLAN TAB.

Community Member

Re: associate only with one access point

Thanks friends,

I found the problem.

The problem is I enabled WLAN Override and I didn't check any SSID , So I disabled it in the APs and now it works normaaly,

Good Luck,

134
Views
4
Helpful
2
Replies
CreatePlease to create content