I have a 1121 AP and manual PAC provisioning passed but automatic does not. What debug statements can I use to troubleshoot this? I'm also using local RADIUS on the AP and CSSC 220.127.116.11 which I believe does not support manual PAC file import
Make sure that by default, when you use EAP-MSCHAP inner methods, ACS allows authentication attempts up to the specified value you configured on the Service page inside the TLS tunnel if the initial authentication attempt fails. After the fourth failed authentication attempt inside the SSL tunnel, ACS terminates the EAP conversation, resulting in a RADIUS access-reject.
ACS supports issuing an out-of-band PAC file that allows you to generate a PAC that can be downloaded to ACS.
Transferring Crash file from standby: Login to the Active WLC in HA.
From CLI: (Cisco Controller) >transfer upload datatype crash (Cisco
Controller) >transfer upload filename (Cisco
Controller) >transfer upload mode tftp (Cisco Controller) >transfer
This is the start of a display filter cross reference between Wireshark
and OmniPeek. The 1st installment is a table of advanced filters. More
filters will be added as time allows. It is a living doc, so check back
for changes every so often Please feel f...