I am looking for a way to obtain the SSID mac addresses from a report or other method. We have clients attaching to an SSID that show a MAC address that I am positive is the MAC of the SSID (based off the physical MAC of the Radio) but I cannot find it either in reports in WCS or on the controller.
When you configure more than one SSID on an AP Automous or lightweight, the additional SSID's are assigned their own BSSID(MAC address) the current method to do this is to increment the burned in(physical) MAC address by one. For exambple the first SSID would have as the last octet of the mac address 00 the next SSID will have the last octet of 01 so on and so forth until 0F is reached giving you the abilty to assigh 16 SSID's to an AP.
Thanks! That's what I figured however I am looking for a place where the information (Mac address) for each SSID is. I can see logically how it breaks down but I have a customer with devices that read this MAC as their AP mac and I need to be able to locate the AP they are attached to. Thanks !
Transferring Crash file from standby: Login to the Active WLC in HA.
From CLI: (Cisco Controller) >transfer upload datatype crash (Cisco
Controller) >transfer upload filename (Cisco
Controller) >transfer upload mode tftp (Cisco Controller) >transfer
This is the start of a display filter cross reference between Wireshark
and OmniPeek. The 1st installment is a table of advanced filters. More
filters will be added as time allows. It is a living doc, so check back
for changes every so often Please feel f...