Block hosts to communicates

[omar_elmohri]

Hello,

anyone can help me find the command to use to deny any host to communicate with an other connected at the same access point?

I have a 1231 Aironet AP.

Thanks,

Omar,

[jolmo · Accepted solution]

Hi Omar

under "interface Dot11Radio0" use:

bridge-group 1 port-protected

For more info:http://www.cisco.com/en/US/products/hw/wireless/ps430/products_configuration_guide_chapter09186a00801d0179.html#wp1038494

Hope this helps

[scottmac]

In the WebGUI, under the radio config, there's a checkbox labeled "Public Secure Packet Forwarding (PSPF) ... checking that (enabling it) will prevent a client of the access point from accessing another client on the same access point.

Good Luck

Scott