Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

Block hosts to communicates

Hello,

anyone can help me find the command to use to deny any host to communicate with an other connected at the same access point?

I have a 1231 Aironet AP.

Thanks,

Omar,

1 ACCEPTED SOLUTION

Accepted Solutions
Silver

Re: Block hosts to communicates

Hi Omar

under "interface Dot11Radio0" use:

bridge-group 1 port-protected

For more info:http://www.cisco.com/en/US/products/hw/wireless/ps430/products_configuration_guide_chapter09186a00801d0179.html#wp1038494

Hope this helps

2 REPLIES
Silver

Re: Block hosts to communicates

Hi Omar

under "interface Dot11Radio0" use:

bridge-group 1 port-protected

For more info:http://www.cisco.com/en/US/products/hw/wireless/ps430/products_configuration_guide_chapter09186a00801d0179.html#wp1038494

Hope this helps

Green

Re: Block hosts to communicates

In the WebGUI, under the radio config, there's a checkbox labeled "Public Secure Packet Forwarding (PSPF) ... checking that (enabling it) will prevent a client of the access point from accessing another client on the same access point.

Good Luck

Scott

116
Views
5
Helpful
2
Replies
CreatePlease to create content