I have setup WLSE 2.11, and everything is working great. The rogue detection works fine, but appears to be picking up bluetooth phones, mice, printers, etc... I don't know what else it could be because I don't see how one AP in one dorm could detect 40+ Ad-hoc rogues. The APs are set for b/g, and I know bluetooth is also 2.4 GHz.
Is this probably what is happening? Is there anyway to fiter them out?
The behaviour that you are seeing is normal. Since the microwave and other bluetooth devices operate in the same frequency range they will also be detected as rogue devices. To eliminate these devices to be detected as rogue devices, you have to physically remove these devices for the WLAN area.
Transferring Crash file from standby: Login to the Active WLC in HA.
From CLI: (Cisco Controller) >transfer upload datatype crash (Cisco
Controller) >transfer upload filename (Cisco
Controller) >transfer upload mode tftp (Cisco Controller) >transfer
This is the start of a display filter cross reference between Wireshark
and OmniPeek. The 1st installment is a table of advanced filters. More
filters will be added as time allows. It is a living doc, so check back
for changes every so often Please feel f...