Cisco Support Community
Showing results for 
Search instead for 
Did you mean: 
You may experience some slow load times, errors, and slight inconsistencies. We ask for your patience as we finalize the launch. Thank you.

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

BR340 8.80 filter problems

After upgrading from v8.65 to v8.80 of firmware on BR340 and BR500 devices most protocol filters were automatically removed. We had it set to discard protocols not in the forward list so most traffic stopped. ARP and STP were the only two still in the forward list.

If I add the inet and novell filters back in they work until bridge is restarted. Added protocol filters are not saved. If I change the default from discard to forward this setting is saved.

Any ideas?

  • Security and Network Management