cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
344
Views
0
Helpful
1
Replies

Can Ap's Joined to a WLC use SNMP

sbeauton
Level 1
Level 1

I have 18 AP's currently joined to my WLC. Code is 5.0.148.0. I have the SNMP string on the WLC but I'm wondering if I can put an SNMP string on the AP's. If so how do I do it. Thanks

1 Reply 1

Rob Huffman
Hall of Fame
Hall of Fame

Hi Scott,

Q. Can a LAP AP handle SNMP messages like an IOS AP?

A. The LAP APs cannot handle SNMP messages on their own. In order to handle SNMP messages, you should configure an SNMP community on the WLC to which the LAP is registered. All the AP information is managed by the WLC.

From this good Q & A doc (**at the very end of the doc);

http://www.cisco.com/en/US/products/hw/wireless/ps430/products_qanda_item09186a00806a4da3.shtml

From Jake @ Cisco;

http://forum.cisco.com/eforum/servlet/NetProf?page=netprof&forum=Wireless%20-%20Mobility&topic=General&CommCmd=MB%3Fcmd%3Dpass_through%26location%3Doutline%40%5E1%40%40.1dde2a24/0#selected_message

Hope this helps!

Rob

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: