Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

Can Ap's Joined to a WLC use SNMP

I have 18 AP's currently joined to my WLC. Code is 5.0.148.0. I have the SNMP string on the WLC but I'm wondering if I can put an SNMP string on the AP's. If so how do I do it. Thanks

1 REPLY
Hall of Fame Super Red

Re: Can Ap's Joined to a WLC use SNMP

Hi Scott,

Q. Can a LAP AP handle SNMP messages like an IOS AP?

A. The LAP APs cannot handle SNMP messages on their own. In order to handle SNMP messages, you should configure an SNMP community on the WLC to which the LAP is registered. All the AP information is managed by the WLC.

From this good Q & A doc (**at the very end of the doc);

http://www.cisco.com/en/US/products/hw/wireless/ps430/products_qanda_item09186a00806a4da3.shtml

From Jake @ Cisco;

http://forum.cisco.com/eforum/servlet/NetProf?page=netprof&forum=Wireless%20-%20Mobility&topic=General&CommCmd=MB%3Fcmd%3Dpass_through%26location%3Doutline%40%5E1%40%40.1dde2a24/0#selected_message

Hope this helps!

Rob

191
Views
0
Helpful
1
Replies
CreatePlease to create content