Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Can I change roaming characteristics on a controller

Folks,

              I have fixing a very bad design where the coverage is not good. The users are complaining that when they roam their phones get disconnected as the APs are connected to controllers in different subnets and cckm does not work well in inter subnet roaming. The client should have done a proper site servey before deploying access points. Is there a way I can fine tune the roaming characteristics of the controller so that the clients do not roam that offten leading to disconnet calls?

Parwal

1 REPLY

Can I change roaming characteristics on a controller

Hi Navin,

Its my opinion if you start getting fancy with changing romaing you will ask for even more problems. If the network is properly deisgned and a soild survey was done you shouldnt have to get fancy.

A few quick questions..

1. Why the L3 roam ?

2. Is there proper cell over lap

3. What model phones are you using

__________________________________________________________________________________________ "Satisfaction does not come from knowing the solution, it comes from knowing why." - Rosalind Franklin ___________________________________________________________
195
Views
0
Helpful
1
Replies
CreatePlease login to create content