Need help with accessing CLI, when I try to do it with SSH, Telnet and SSH2 it comes back immtiately with connection refused. I have been to the WCS GUI and made sure SSH is checked and saved for CLI found on tab Administration--> settings --> CLI. I need the CLI to export Data for NCS. Advise appreciated.
Transferring Crash file from standby: Login to the Active WLC in HA.
From CLI: (Cisco Controller) >transfer upload datatype crash (Cisco
Controller) >transfer upload filename (Cisco
Controller) >transfer upload mode tftp (Cisco Controller) >transfer
This is the start of a display filter cross reference between Wireshark
and OmniPeek. The 1st installment is a table of advanced filters. More
filters will be added as time allows. It is a living doc, so check back
for changes every so often Please feel f...