Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Can't enable EAP or LEAP on client

Can anyone tell me what I am doing wrong?? I have a 340 Access Point running IOS 11.7 and radio firmware 4.25 and have Draft 10 enabled. On the client I have a Cisco 340 PCI card and the same radio firmware and version 6.97 of the NDIS driver and I am using Windows 98 SE. Using the client utilites version 4.15.006, I can't enable LEAP or EAP on the client, it is greyed out. Am I missing something? I am using the beta code from Funk Software for LEAP as my RADIUS server. Any help would be greatly appreciated!!!

  • Security and Network Management
1 REPLY
New Member

Re: Can't enable EAP or LEAP on client

FIXED. Had to go back and uninstall the ACU software. At that point I was able to reconfigure the utility to use LEAP. I have had the software on my laptop for a long time and forgot that that was an option when initially installing the software. Now onto getting the Access Point and RADIUS server talking properly....

186
Views
0
Helpful
1
Replies
This widget could not be displayed.