Switch port shows me a lot of errors and collisions. I do not know what excatily is happening here, why those errors/collisions ?
Look for a speed or duplex mismatch between the swtich port and AP I would set both the switch and the AP to 10Mb half duplex. If you still see these errors then try an new cable and then another port on the switch to see if the errors follow ??
Transferring Crash file from standby: Login to the Active WLC in HA.
From CLI: (Cisco Controller) >transfer upload datatype crash (Cisco
Controller) >transfer upload filename (Cisco
Controller) >transfer upload mode tftp (Cisco Controller) >transfer
This is the start of a display filter cross reference between Wireshark
and OmniPeek. The 1st installment is a table of advanced filters. More
filters will be added as time allows. It is a living doc, so check back
for changes every so often Please feel f...