Cannot configure AP521 through ssh, can configure from console though
I got some sort of a challenge over here. We have a couple of 521's which are standalone versions. Because of the limited functionality of the webinterface (and the fact that I configure all cisco's from the console) I am configuring them by hand.
The problem is that I cannot get them into configuration mode when I am connected through ssl. I tried all the tricks I know but no luck yet. I am logged in at privilege level 15 so I should be able to do anything, but no. What am I missing here? From the console there's no problem but when the AP's are mounted (above the ceiling) it would be nice to still be able to configure them if necessary without bringing the roof down every time.
Transferring Crash file from standby:
Login to the Active WLC in HA.
(Cisco Controller) >transfer upload datatype crash
(Cisco Controller) >transfer upload filename <Desired filename>
(Cisco Controller) >transfer up...
This is the start of a display filter cross reference between Wireshark and OmniPeek.
The 1st installment is a table of advanced filters. More filters will be added as time allows.
It is a living doc, so check back for changes every so often
Please feel ...
I have created a Powershell script to automatically add a Wireless Guest User on Cisco WLCs. (tested on 2500 Series)
The script should be completely self explanatory.
Powershell SNMP Module (Install-Module -Name SNMP)
SNMP Write Access to...