Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Attention: The Community will be in read-only mode on 12/14/2017 from 12:00 am pacific to 11:30 am.

During this time you will only be able to see content. Other interactions such as posting, replying to questions, or marking content as helpful will be disabled for few hours.

We apologize for the inconvenience while we perform important updates to the Community.

New Member

Cant add controllers to WCS

Failed to add device to WCS Reason: Object not found in device

what the deuce?

4 REPLIES

Re: Cant add controllers to WCS

Just wondering ...

What version is your WCS and Controllers?

__________________________________________________________________________________________ "Satisfaction does not come from knowing the solution, it comes from knowing why." - Rosalind Franklin ___________________________________________________________
New Member

Re: Cant add controllers to WCS

Wireless Control System

Version 4.2.128.0

Controller Summary

Software Version 5.1.151.0

Re: Cant add controllers to WCS

This can NOT work.

You need to be on a WCS version 5.1 or later.

There are new SNMP string on the 5.1 controller that WCS 4.2 can not recognize.

I suggest you to go directly to WCS 5.2 or 6.0. Do avoid WCS 5.1, too many bugs on that release.

Check the release notes of WCS to see what versions of controllers are supported :

http://www.cisco.com/en/US/products/ps6305/prod_release_notes_list.html

New Member

Re: Cant add controllers to WCS

I pulled down the "latest" release. I was kinda wondering why it was 4.2 and the 6 dots where below it.

I will get 6

861
Views
5
Helpful
4
Replies
CreatePlease to create content