Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

change the password for controller based Access Points on the WCS

How can I change the password for controller based Access Points on the WCS?

On the controller itself I know how it is done.( config ap username <USERNAME>password <PASSWORD> <all | AP Name>

But how is it done on the WCS wher 3 controller exists?

Thanks for an answer

2 REPLIES
New Member

Re: change the password for controller based Access Points on th

this will be available in WCS release 5.1.x.x (under "configure - controller templates - system")

Cisco Employee

Re: change the password for controller based Access Points on th

global username and password can be changed via:wcs.this feature was supported on wcs:5.0.56.0.

1)click configure>(click link under name of any controller>system>AP username and password.

2)give AP username and password .

3)give enable username and password.

4)click save.

now try to login to any of your AP using this username and password.ANY future AP joining controller will use this username and password.

if you want particular AP username and password to be changed.then

1) click AP.CLICK link under ap name.

2)enable check box over ride global username and password.

3) give username and password

4)give AP enable username and password.

5)click save.

136
Views
0
Helpful
2
Replies