login as an administrator using either console or telnet (telnet is disabled by default, enable it via web interface or 'telnetenable' command on console) and as you type 'show configuration', it will show you kinda useful info and give you good hints on how to change the setting.
in order to change ip address;
interface ethernet0 x.x.x.x 255.255.255.x default-gateway x.x.x.x up
Transferring Crash file from standby:
Login to the Active WLC in HA.
(Cisco Controller) >transfer upload datatype crash
(Cisco Controller) >transfer upload filename <Desired filename>
(Cisco Controller) >transfer up...
This is the start of a display filter cross reference between Wireshark and OmniPeek.
The 1st installment is a table of advanced filters. More filters will be added as time allows.
It is a living doc, so check back for changes every so often
Please feel ...
I have created a Powershell script to automatically add a Wireless Guest User on Cisco WLCs. (tested on 2500 Series)
The script should be completely self explanatory.
Powershell SNMP Module (Install-Module -Name SNMP)
SNMP Write Access to...