Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

Changing the default management VLAN

I've been trying to change the management VLAN of my AP. Initially, I left everything as the default, which means that BVI1 is tied to the native VLAN. And the native VLAN is 1. My management VLAN was also VLAN1.

Cisco recommends changing the management VLAN of your devices to something other than 1. They also recommend using an unused VLAN for the native trunking VLAN. This means that the native and management VLANs have to be different and something other than 1.

How do I create a BVI that uses VLAN 200, without also changing the native VLAN to 200?

I've tried creating an ethernet subinterface fastethernet 0.200, and a BVI 200, but the device remains unreachable.

3 REPLIES
Silver

Re: Changing the default management VLAN

Management Vlan and Native Vlan need to be in Same vlan for access points and bridge. So the statement "Cisco recommends changing the management VLAN of your devices to something other than 1. They also recommend using an unused VLAN for the native trunking VLAN" dosnt mean different vlans for the interfaces.

New Member

Re: Changing the default management VLAN

Hi, I have the same requirement, I need to manage the AP through tagged packet, not the native vlan.

The AP trunked port should carry all the ssid operative vlan plus the AP management vlan.

thank you in advance

greatings

RS

New Member

Re: Changing the default management VLAN

Your config would look something like this. Remember to configure your switch interface as a trunk port.

interface Dot11Radio0.xxx

encapsulation dot1Q xxx native

no ip route-cache

bridge-group xxx

bridge-group xxx subscriber-loop-control

bridge-group xxx block-unknown-source

no bridge-group xxx source-learning

no bridge-group xxx unicast-flooding

bridge-group xxx spanning-disabled

!

interface Dot11Radio0.xxx

encapsulation dot1Q xxx

no ip route-cache

bridge-group xxx

bridge-group xxx subscriber-loop-control

bridge-group xxx block-unknown-source

no bridge-group xxx source-learning

no bridge-group xxx unicast-flooding

bridge-group xxx spanning-disabled

!

interface FastEthernet0

no ip address

no ip route-cache

speed 100

full-duplex

hold-queue 160 in

!

interface FastEthernet0.xxx

encapsulation dot1Q xxx native

no ip route-cache

bridge-group xxx

no bridge-group xxx source-learning

bridge-group xxx spanning-disabled

!

interface FastEthernet0.108

encapsulation dot1Q xxx

no ip route-cache

bridge-group xxx

no bridge-group xxx source-learning

bridge-group xxx spanning-disabled

!

interface BVI1

ip address x.x.x.x x.x.x.x

no ip route-cache

Thanks,

Jake

834
Views
0
Helpful
3
Replies
CreatePlease to create content