A colleague of mine recently changed the IP addresses of the WLCs and the MSE in advance of a planned Data Center migration. While the IP address of the MSE is reachable from PI, PI still sees it as its old IP address. I thought to myself, "No problem, I'll just go into PI and let PI know that it has a new IP address". Then, after a few minutes, I thought to myself "Wait, what?!?!? The IP address field is not editable?!?!?!". How do I get PI to see the new IP address of the MSE? Do I have to delete/re-add?
Transferring Crash file from standby: Login to the Active WLC in HA.
From CLI: (Cisco Controller) >transfer upload datatype crash (Cisco
Controller) >transfer upload filename (Cisco
Controller) >transfer upload mode tftp (Cisco Controller) >transfer
This is the start of a display filter cross reference between Wireshark
and OmniPeek. The 1st installment is a table of advanced filters. More
filters will be added as time allows. It is a living doc, so check back
for changes every so often Please feel f...