In the ceiling of our service department we have a cisco 1100 router wired into a switch. This switch is firewalled and a particular IP address, subnet mask, and gateway must be set. The password was set back in 2007 and then subsequently lost. This was not a problem until it was time to replace the laptops in the shop. I went through the password reset procedure and now nothing will connect to the router.
1. I unplugged the ethernet cable (this also supplies power)
2. Plugged it back in while holding the "mode" button until the light turned amber (2-3 seconds)
Now the unit only flashes the green lights and none of my laptops will reconnect to it or find it on the network. How to I go about resetting this unit and basically start from scratch?
Transferring Crash file from standby:
Login to the Active WLC in HA.
(Cisco Controller) >transfer upload datatype crash
(Cisco Controller) >transfer upload filename <Desired filename>
(Cisco Controller) >transfer up...
This is the start of a display filter cross reference between Wireshark and OmniPeek.
The 1st installment is a table of advanced filters. More filters will be added as time allows.
It is a living doc, so check back for changes every so often
Please feel ...
I have created a Powershell script to automatically add a Wireless Guest User on Cisco WLCs. (tested on 2500 Series)
The script should be completely self explanatory.
Powershell SNMP Module (Install-Module -Name SNMP)
SNMP Write Access to...