Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Cisco 1200 Aironet Access point and MAC Auth.

I am trying to use WEP and MAC auth for my access point. The WEP side works fine but when I enter a MAC address and set it to allow that works and any other wireless NIC I plug into my machine. Can anyone tell me what I am missing so only the correct WEP and only Allowed MAC's will be able to access the acess point.

Thanks, Dan

1 REPLY
Cisco Employee

Re: Cisco 1200 Aironet Access point and MAC Auth.

Sounds like you config is not right but really hard to say given the info you have here

Make sure you configure exactly as per this

http://www.cisco.com/univercd/cc/td/doc/product/wireless/airo1200/accsspts/ap120scg/bkscgc8.htm#1031298

If you are not running leap and mac then is mac alone enough to be fully authenticated should be set to 'no' this is the most common mistake people make

618
Views
0
Helpful
1
Replies
CreatePlease login to create content