Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

Cisco 1941W configure mac authentication in wireless

Dear all, 

    Appreciate that anyone know how to configure mac authentication in 1941w router?

    Perhaps can show me some example of configure mac authentication in 1941w router. 

 

2 ACCEPTED SOLUTIONS

Accepted Solutions
Hall of Fame Super Silver

If your trying to configure

If your trying to configure mac filtering on the access point in the 1941w and the AP is autonomous, you can follow this guide:

http://www.cisco.com/c/en/us/support/docs/wireless-mobility/wireless-lan-wlan/116582-configure-ap-00.html

Scott

-Scott
*** Please rate helpful posts ***
Cisco Employee

Hi,For MAC filtering In case

Hi,

For MAC filtering In case of autonomous AP creating access-list, use the below command

 

Test-AP# configure terminal

Test-AP(conf)# access-list 700 deny <mac-address you want filter/deny>

 

 For light weight follow the below process:

 

http://www.cisco.com/c/en/us/td/docs/wireless/controller/4-2/configuration/guide/ccfig42/c42lwap.html#wp1115915

 

Thanks & Regards

Sandeep

 

5 REPLIES
Cisco Employee

Hi,Below is the configuration

Hi,

Below is the configuration for mac authentication bypass on cisco 1900 router

 

c1921> enable
c1921# configure terminal
c1921(conf)#interface gigabitethernet slot / port
c1921(conf-if)# authentication port-control auto
c1921(conf-if)# mab
c1921(conf-if)# end

 

> You can verify using the below command

c1921#show authentication sessions 
Interface MAC Address Method Domain Status Session ID
Gi0/1 0201.0201.0201 mab DATA Authz Success 0303030300000004002500A8
c1921#show authentication sessions interface Gi0/1
 Interface: GigabitEthernet0/1
 MAC Address: 0201.0201.0201
 IP Address: Unknown
 User-Name: 02-01-02-01-02-01
 Status: Authz Success

Domain: DATA
 Oper host mode: single-host
 Oper control dir: both
 Authorized By: Authentication Server
 Vlan Group: N/A
 AAA Policies: 
 Session timeout: N/A
 Idle timeout: N/A
 Common Session ID: 0303030300000004002500A8
 Acct Session ID: 0x00000007
 Handle: 0x3D000005
Runnable methods list:
 Method State
 mab Authc Success

 

For more details refer the below link:

 

http://www.cisco.com/c/en/us/td/docs/routers/access/1900/software/configuration/guide/Software_Configuration/conf.pdf

 

Thanks & Regards

Sandeep

New Member

Hi Sandeep, Thanks for your

Hi Sandeep, 

Thanks for your document. 

But this is the mac authentication bypass. How about if I want to control user authentication by manual configure mac address in authentication to control the wifi access?

 

Best regards

TPPSupport

Hall of Fame Super Silver

If your trying to configure

If your trying to configure mac filtering on the access point in the 1941w and the AP is autonomous, you can follow this guide:

http://www.cisco.com/c/en/us/support/docs/wireless-mobility/wireless-lan-wlan/116582-configure-ap-00.html

Scott

-Scott
*** Please rate helpful posts ***
New Member

Thanks guys, I able to use

Thanks guys, 

I able to use the mac-list to control the mac address filtering. 

Cisco Employee

Hi,For MAC filtering In case

Hi,

For MAC filtering In case of autonomous AP creating access-list, use the below command

 

Test-AP# configure terminal

Test-AP(conf)# access-list 700 deny <mac-address you want filter/deny>

 

 For light weight follow the below process:

 

http://www.cisco.com/c/en/us/td/docs/wireless/controller/4-2/configuration/guide/ccfig42/c42lwap.html#wp1115915

 

Thanks & Regards

Sandeep

 

192
Views
0
Helpful
5
Replies
CreatePlease to create content