Greetings, ive configured the 4400 controllers before and am familiar with the terms involved, ive recently acquired a 2106 controller, i have assigned an AP Manager and Management Address to Port 1 on the same subnet and can ping the device.
Subsequently i have several different vlans with differing subnets that i want to provide wireless services too as well as a guest network.
As such i have configured the WLAN's and associated each one to it's own dynamic interfaces. Each dynamic interface is in turn associated to it's own port on the controller.
Port 1 - AP Manager/Management
Port 2 - Dynamic Interface - WLAN A
Port 3 - Dynamic Interface - WLAN B
Port 4 - Dynamic Interface - WLAN C
And so on, unfortunately when configuring this i lose connection to the controller, if i put all dynamic and static interfaces onto a single port it works fine.
Im running Rapid PVST+ on my switches and am thinking it may be a spanning-tree issue but need clarification if what im doing is actually possible?
Transferring Crash file from standby: Login to the Active WLC in HA.
From CLI: (Cisco Controller) >transfer upload datatype crash (Cisco
Controller) >transfer upload filename (Cisco
Controller) >transfer upload mode tftp (Cisco Controller) >transfer
This is the start of a display filter cross reference between Wireshark
and OmniPeek. The 1st installment is a table of advanced filters. More
filters will be added as time allows. It is a living doc, so check back
for changes every so often Please feel f...