Usually the release of the AP Firmware coincides (and matches) the release of the Firmware for the Radio Cards. In this release, the Firmware of the Radio in the AP is v4.25.22 and the Firmware of the Radio's in the PCI cards has been updated to v4.25.23. Is this correct?
Also just being picky here: Why is it that depending upon what screen you're looking at in the AP you see firmware listed in two ways (ie: v4.25V or v4.25.22)? Yes I noticed that V is the 22 letter but why two naming conventions depending on what screens you're on?
Since there has been no response to your post, it appears to be either too complex or too rare an issue for other forum members to assist you. If you don't get a suitable response to your post, you may wish to review our resources at the online Technical Assistance Center (http://www.cisco.com/tac) or speak with a TAC engineer. You can open a TAC case online at http://www.cisco.com/tac/caseopen
If anyone else in the forum has some advice, please reply to this thread.
Transferring Crash file from standby: Login to the Active WLC in HA.
From CLI: (Cisco Controller) >transfer upload datatype crash (Cisco
Controller) >transfer upload filename (Cisco
Controller) >transfer upload mode tftp (Cisco Controller) >transfer
This is the start of a display filter cross reference between Wireshark
and OmniPeek. The 1st installment is a table of advanced filters. More
filters will be added as time allows. It is a living doc, so check back
for changes every so often Please feel f...