I am using 70 1131 Aps with Cisco 4408 WLC. Now I am going to migrate my WLC with Cisco 5508. Do i need to purchase different AP count license for my new WLC or is there any way i can migrate the license from existing Cisco 4408 to Cisco 5508 WLC.
I am unable to get the license information from my Cisco WLC 4408. In the main page, i am able to see 100 APs are supported, however I am unable to get the license file information from my WLC 4408 which is running with 7.0 version. Usually it used to get in Management tab, but i am not getting the otion in this WLC. Kindly help.
Transferring Crash file from standby: Login to the Active WLC in HA.
From CLI: (Cisco Controller) >transfer upload datatype crash (Cisco
Controller) >transfer upload filename (Cisco
Controller) >transfer upload mode tftp (Cisco Controller) >transfer
This is the start of a display filter cross reference between Wireshark
and OmniPeek. The 1st installment is a table of advanced filters. More
filters will be added as time allows. It is a living doc, so check back
for changes every so often Please feel f...