Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Cisco IOS and LEAP

I upgrade a test AP to the new code of IOS for the Aironet 1200s. Before the upgrade we were using LEAP for authentication and it worked fine. With the upgrade, I can not get LEAP to work. We are using Cisco ACS 3.1 for our Radius servers. I believ all my configurations under security are correct, but not 100% positive. Are there different configurations for LEAP between VxWorks and IOS?

4 REPLIES
Cisco Employee

Re: Cisco IOS and LEAP

IOS sends a different nas-port type than VxWorks

This is reported by bug id CSCeb36095

IOS based APs will pass Radius attribute 61 (NAS-Port-Type) with value 5

(virtual), while VxWorks based APs use value 19 (Wireless IEEE802.11)

Users may need to re-configure Radius server setting if this attribute is used

to grant access to the user, when changing AP from VxWorks to IOS.

New Member

Re: Cisco IOS and LEAP

Where do I find these settings to compare/change? On the AP itself or the RADIUS server?

Thanks

Cisco Employee

Re: Cisco IOS and LEAP

On the radius server

New Member

Re: Cisco IOS and LEAP

I hate to sound like an idiot, but where on the Radius servers do I find these settings? We are using both ACS v2.6 and v3.1, and I could not find these settings on either of them.

Thanks

425
Views
0
Helpful
4
Replies
CreatePlease login to create content