08-04-2003 12:18 PM - edited 07-04-2021 08:54 AM
I upgrade a test AP to the new code of IOS for the Aironet 1200s. Before the upgrade we were using LEAP for authentication and it worked fine. With the upgrade, I can not get LEAP to work. We are using Cisco ACS 3.1 for our Radius servers. I believ all my configurations under security are correct, but not 100% positive. Are there different configurations for LEAP between VxWorks and IOS?
08-04-2003 07:09 PM
IOS sends a different nas-port type than VxWorks
This is reported by bug id CSCeb36095
IOS based APs will pass Radius attribute 61 (NAS-Port-Type) with value 5
(virtual), while VxWorks based APs use value 19 (Wireless IEEE802.11)
Users may need to re-configure Radius server setting if this attribute is used
to grant access to the user, when changing AP from VxWorks to IOS.
08-05-2003 04:20 AM
Where do I find these settings to compare/change? On the AP itself or the RADIUS server?
Thanks
08-05-2003 05:08 AM
On the radius server
08-05-2003 05:27 AM
I hate to sound like an idiot, but where on the Radius servers do I find these settings? We are using both ACS v2.6 and v3.1, and I could not find these settings on either of them.
Thanks
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: