Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Cisco LWAP issue

Hi ,

I am having 3 nos of AIR-LAP1242AG-A-K9,I have configured successfully with WLC,but one problem I am facing with one LAP ,out of 3 two LAPs are working fine.Which are 4.0 ver,all the interfaces are showing up,but in one of the LAP ,it show only fastethernet interface and it is not showing RF interface.Which has the 3.0 ver.When i approached Cisco , they send a replacement,which is also 3.0,again it is not showing thr RF interface.

Now I want to upgrade the IOS of that AIR-LAP1242AG-A-K9,Can any one give the procedure.

Thanks and Regards,

S.Venkataraman.

  • Security and Network Management
1 REPLY

Re: Cisco LWAP issue

The AIR-LAP1242AG-A-K9 are for use with the unified wireless system ( controller based)

The Ap will be upgraded or downgraded depending upon what version is on the controller. As soon as the Ap registers with the controller, the upgrade will start and then the AP will reboot with the latest code available from the controller.

If you are referring to the non lwapp 1242 radios, AIR-AP1242AG-A-K9 802.11a/g Non-modular , then you can upgrade them via their web interface or from the command line

96
Views
0
Helpful
1
Replies
This widget could not be displayed.