Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Cisco Ncs and switches

OK i've setupa a switch for read only access (public community ) on ncs

this is not  a dot1x but setup with syslog traps on new mac on most non-trunk interfaces

everything is fine except for one thing

on client monitoring the client ip is not visible (data not available)   ... is there a way to view this data?

there are some voip phones (on voip vlan) and a printer

traffic report is 0.... I assume this is ok 'cause the port traffic is low, however  i'd like to know if this is to be considered a normal behaviour

tahnks

Everyone's tags (2)
307
Views
0
Helpful
0
Replies