Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Users might experience few discrepancies in Search results. We are working on this on our side. We apologize for the inconvenience it may have caused.
New Member

Cisco Prime Infrastructure EoL/EoS and PSIRT reports

Hi

does PI 2.0 support these reports?

I have a trial version of 2.0, but can't seem to find these reports. In the release notes, it says these are supported?

New Features and Enhancements

Support for End-of-Sale/End-of-Life Lifecycle Management reports for hardware, software and modules.

Support for PSIRT reports detailing devices impacted by Cisco security advisories.

Any idea how to run these reports?

Thanks for your help

7 REPLIES
New Member

Cisco Prime Infrastructure EoL/EoS and PSIRT reports

The compliance server is disabled by default. It needs to be enabled, rebooted and resync'd to be able to use psirt etc

Cisco Prime Infrastructure EoL/EoS and PSIRT reports

check the report managment from the below link , it answers lot of queries including yours

http://www.cisco.com/en/US/docs/net_mgmt/ciscoworks_lan_management_solution/4.1/user/guide/reports/appendix_rpt.html#wp1015015

New Member

Cisco Prime Infrastructure EoL/EoS and PSIRT reports

That link refers to Prime LMS 4.1 not Prime Infrastructure 2.0

New Member

Cisco Prime Infrastructure EoL/EoS and PSIRT reports

Unfortunately EoL/EoS is not available within Cisco PI 2. (https://supportforums.cisco.com/message/4158676#4158676). However you can enable Compliance from the settings (somewhere) from the Administrative menu. Save and reboot the server and then you have PSIRT reports within the Compliance section in Reporting aswell.

Re: Cisco Prime Infrastructure EoL/EoS and PSIRT reports

You can use Cisco Discovery Service to create EoX reports.
http://www.netformx.com/userfiles/file/CDS2_AAG_FINAL_April2012.pdf

Hall of Fame Super Silver

Cisco Prime Infrastructure EoL/EoS and PSIRT reports

You can also use the Cisco Active Advisor free tool for EoS/EoL and PSIRTs:

http://www.cisco.com/c/en/us/products/cloud-systems-management/active-advisor/index.html

New Member

Hi There, I'm not sure if we

Hi There,

 

I'm not sure if we are talking about the same thing, but we are running Prime Infrastructure 2.0. (2.0 (2.0.0.0.294))

You have to enable compliance from the settings (restart) and if you look under Report / Report Launch Pad, in the menu on the left is Device, click on there and you will see EOX ...... I've only had a quick look at the reports, but looks to work.


HTH

Simon 

3442
Views
5
Helpful
7
Replies
CreatePlease to create content