Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Cisco Prime NCS Mapping Question

I am trying to setup maps within Cisco NCS for a building.

I have done this many times in the past but it has always been with very straightforward rectangular maps.

This time I have a building which is separated into two parts - an office area and a warehouse (high ceiling) type of area.

The issue I am trying to get around is that they are connected through a long wall that  bends across the length of the entire structure (image below of whole space.)

If I just use the below map for the entire dimensions of the building the problem is that I can only set one ceiling height which isnt the case at all since the warehouse ceiling is much higher than the office area.

If I split these out and try to use two separate areas, I have to overlay them somehow to get them to line up properly, but then NCS gives me an error that the two areas are intersecting.

I am kind of at a loss on how to proceed from here but maybe there is an easy solution I am missing.

Anyone have any ideas on how to accomplish building this floor plan in NCS prime?  In the image below the L-shape turned on its side is the warehouse area.  And the office area is the lower part in an upside down Z shape.

Thanks,

Tim

Floor1.png

Everyone's tags (5)
2 REPLIES
New Member

Cisco Prime NCS Mapping Question

Well, now that I have upgraded to Prime Infrastructure I still face the same problem.

Since it's been over a year I thought I'd see if anyone has come up with any people have any new ideas for me?

Thanks,

Tim

Bronze

Re: Cisco Prime NCS Mapping Question

We still use WC'S. This only displays a warming, not an error.
Maybe there is a campus setting to enable overlapping buildings?

Sent from Cisco Technical Support iPad App

548
Views
0
Helpful
2
Replies
CreatePlease login to create content