Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Cisco Prime repeated PoE error message

Dear community,

 

I'm getting since a recent migration the following messages into Cisco Prime 2.x :

 

POE status

Message: Access point 'AP5087.xxxx.xxxx' associated with controller 'xyzxyz' draws low power from Ethernet. Failure reason: 'The AP draws low power from Ethernet'. - Controller Name: xyzxyz

 (6 times)

 

I have this messages on switches that are old and recent like 4506 with PoE card and also with 2960X full PoE.

One AP is a old 1131AG and the other is a recent 2602i...

AP are working correctly, I don't see something abnormal on the switch when doing a "show power inline"

However I don't get why I got those messages and what could be the resolution for it...

Both switches have enough remaining power to provide...

I'm available to provide some more info if wished

Thanks a lot

Regards

  • Security and Network Management
Everyone's tags (1)
3 REPLIES
Gold

Refer the BUG: CSCuq79884

Refer the BUG: CSCuq79884

New Member

Oh thanks for this

Oh thanks for this information,

What is the patch correcting this, if there's any...?

No workaround for this bug

No workaround for this bug

237
Views
0
Helpful
3
Replies
This widget could not be displayed.