Welcome to Cisco Support Community. We would love to have your feedback.
For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.
I am Cisco WiSM consists of two Cisco 4404 controllers which is installed on the 6503 Switch. I am using Mac Address based authentication for clients to get connect.
When i am adding a new client's mac address to one controller, it is not reflecting to the Controller B. I have to manually make the entry in Controller B also.
Is this a problem related to Mobility Group configuration??
To export the Mac filters from one controller to another, create a template using WCS and push it out to both controllers. Otherwise, you'd just have to refer to the mac-address list on one while implementing it on the other.