Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

CLI Configuration of WLC 5508 w 7.0.250.0

Hi all.  Is there a way to get the configuration of a WLC through the CLI similar to that of what you'd get from Cisco IOS?  So far I've tried

config paging disable

show running-config

and

show run-config

but the output doesn't look like that of what you could cut/paste like IOS. 

 

Thanks for all input.

  • Security and Network Management
1 ACCEPTED SOLUTION

Accepted Solutions
VIP Purple

Hi This is the command you

Hi 

This is the command you have to run

(5508-1) >show run-config commands

If you want to take the backup & restore that to a different WLC, then you have to follow the method given below.

http://mrncciew.com/2013/01/25/backup-restore-wlc-configs/

 

HTH

Rasika

*** Pls rate all useful responses ****

3 REPLIES
VIP Purple

Hi This is the command you

Hi 

This is the command you have to run

(5508-1) >show run-config commands

If you want to take the backup & restore that to a different WLC, then you have to follow the method given below.

http://mrncciew.com/2013/01/25/backup-restore-wlc-configs/

 

HTH

Rasika

*** Pls rate all useful responses ****

New Member

Thanks for the replies. 

Thanks for the replies.  Manannalage i got the CLI way and was able to get a backup of the controller through its GUI.

 

aflander,  I always wondered if the output could be used, being so bulky.  In the past it has helped me for configuring a similar wlan.  anyways, thanks.

New Member

The output you are seeing is

The output you are seeing is the configuration of the controller and every AP attached to it. If your WLC is managing it then generally that information is useless. I myself have never restored a controllers with a config. 

IOS is completely different but the commands are somewhat the same. 

168
Views
0
Helpful
3
Replies