Client Association Rpt, EAP Usernames, WLSM & WLSE
We are slowly migrating all of our APs to use our WLSM (WDS Mode). WLSE sees the WLSMs. Before moving the APs to do mobility groups, the authentications would appear correctly in the WLSE client association report.
However, after moving to the WLSM, i go to "Reports -> Wireless Clients". Under "Client EAP Username" I type in my username (as I am authenticated to the wireless network) and it doesn't show any associated or authenticated information for me.
If, however, I enter in my "Client MAC Address" the station shows up okay, except that there's no "EAP Username".
It's kind of important that we figure out who is logging in where, because the RADIUS server now just has the WLSM logging in, not the actual AP.
Transferring Crash file from standby:
Login to the Active WLC in HA.
(Cisco Controller) >transfer upload datatype crash
(Cisco Controller) >transfer upload filename <Desired filename>
(Cisco Controller) >transfer up...
This is the start of a display filter cross reference between Wireshark and OmniPeek.
The 1st installment is a table of advanced filters. More filters will be added as time allows.
It is a living doc, so check back for changes every so often
Please feel ...
I have created a Powershell script to automatically add a Wireless Guest User on Cisco WLCs. (tested on 2500 Series)
The script should be completely self explanatory.
Powershell SNMP Module (Install-Module -Name SNMP)
SNMP Write Access to...