Buy or Renew
Buy or Renew
Cisco Virtual Engineer generative AI bot now active in Wireless Discussion Forum. Learn more.
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
cancel
Start a conversation
294
Views
0
Helpful
1
Replies

Client to Client Access Control Question

arnis
Level 1
Level 1

‎02-16-2004 06:44 AM - edited ‎07-04-2021 09:21 AM

Hi

do any of you know if I can configure a AP1200 Access Point so that the Wireless Clients connected to it can not comunicate with each other, but just with devices connected by wire to the access point ?

Labels:
0 Helpful
1 Reply 1

michael.kopp
Level 1
Level 1

‎02-16-2004 07:35 AM

Hi,

yes it`s supported

look at PSPF (Public Secure Packet Forwarding) it does the requested blocking of Inter-Client Communication.

Michael

Here is a link

http://www.cisco.com/en/US/products/hw/wireless/ps430/products_installation_and_configuration_guide_chapter09186a008014868c.html#1038494

0 Helpful
Customers Also Viewed These Support Documents
Review Cisco Networking products for a $25 gift card