01-29-2014 03:15 AM - edited 07-05-2021 12:03 AM
Hello,
I know that I can enable Broadcast in the WLC using CLI( config network broadcast enable ). Can I do it in the Web Interface?
Regards.
Solved! Go to Solution.
01-29-2014 03:47 AM
HI,
Ok now I got ur point.
Here is the GUI Procedure to do it .
Controller > General > enable the Broadcasting forwarding
Here is the screenshot:
Regards
DONt forget to rate helpful posts
01-29-2014 03:30 AM
yes you can do it .
Login to WLC GUI.
WLAN > Click on WLAN ID > General > then check the box for broadcast.
Regards
Dont forget to rate helpful posts
01-29-2014 03:40 AM
I think that you don't understand my question.
The answer you give me corresponds to the following command:
config wlan broadcast-ssid enable
The command that I'm referring to is :
config network broadcast enable
Regards
01-29-2014 03:47 AM
HI,
Ok now I got ur point.
Here is the GUI Procedure to do it .
Controller > General > enable the Broadcasting forwarding
Here is the screenshot:
Regards
DONt forget to rate helpful posts
01-29-2014 03:57 AM
Correct Answer
Thank you!
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: