Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Community Member

Config WLAN override in CLI

I currently have case open with TAC where my LWAPs are losing their override settings . The workaround that I was given is to manually adding SSIDs to the override settings via the GUI. The GUI sucks for this. Can't do text search and you can't sort the columns.

Is there a command to add SSID to the override settings in CLI?

1 ACCEPTED SOLUTION

Accepted Solutions
Hall of Fame Super Red

Re: Config WLAN override in CLI

Hi Wilfred,

Using the CLI to Enable WLAN Override

To enable the WLAN Override option using the controller CLI, enter this command:

config ap wlan enable {802.11a | 802.11b} cisco_ap

To define which WLANs you wish to transmit, enter this command:

config ap wlan add {802.11a | 802.11b} wlan-id cisco_ap

From this good doc;

http://www.cisco.com/en/US/docs/wireless/controller/4.0/configuration/guide/c40wlan.html#wp1114777

Hope this helps!

Rob

2 REPLIES
Hall of Fame Super Red

Re: Config WLAN override in CLI

Hi Wilfred,

Using the CLI to Enable WLAN Override

To enable the WLAN Override option using the controller CLI, enter this command:

config ap wlan enable {802.11a | 802.11b} cisco_ap

To define which WLANs you wish to transmit, enter this command:

config ap wlan add {802.11a | 802.11b} wlan-id cisco_ap

From this good doc;

http://www.cisco.com/en/US/docs/wireless/controller/4.0/configuration/guide/c40wlan.html#wp1114777

Hope this helps!

Rob

Community Member

Re: Config WLAN override in CLI

Also, verify the templates that are being pushed out have the correct wlan override settings if multiple people manage the WCS.

151
Views
0
Helpful
2
Replies
CreatePlease to create content