Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

Configuring Eap-Fast with the Controller 4404

Hi

I was wondering if somebody could help me. As has been noted in a previous thread the documentation really is appaling. I am looking for the following.

1. Version of ACS that supports EAP-Fast with the Controller. I notice that 4.0 has support for Radius(Airespace) as well as IETF and Cisco Radius. Which one do i use?

2. Guide to how to configure the controller? Do I just configure the 802.1x check box and go from there? Someone has mentioned that it just passes through the 802.1x request?

1 REPLY
Bronze

Re: Configuring Eap-Fast with the Controller 4404

The version 4.0 of ACS should support the EAP fast authentication type. For your second question, yes you just have to enable to 802.1x check box on the controller. When you do this the controller will allow all types of EAP packet to go to the radius server.

123
Views
0
Helpful
1
Replies
CreatePlease to create content