Is there a way to configure the ethernet port on the bridge to be a trunk port? I tried using the same commands to set up a trunk port as on a switch, but the same commands were not there. Is this simply a different string of commands to accomplish this, or is it no supported on this bridge?
You cannot configure the port as a trunk, but you can create subinterfaces and add an encap dot1q to them for the vlan numbers. Here is an example of a non-root bridge. I only pasted the applicable commands. Root would have station-role non-root bridge changed to station-role root bridge
dot11 vlan-name VLAN01 vlan 1 dot11 vlan-name VLAN04 vlan 4 ! dot11 ssid V01 vlan 1 authentication open authentication key-management wpa wpa-psk ascii 7 XXXXXYYYY ! dot11 ssid V04 vlan 4 authentication open authentication key-management wpa wpa-psk ascii 7 XXXXXYYYY ! ! ! bridge irb ! ! interface Dot11Radio0 no ip address no ip route-cache ! encryption vlan 1 mode ciphers tkip ! encryption vlan 4 mode ciphers tkip ! ssid V01 ! ssid V04 ! speed basic-1.0 basic-2.0 basic-5.5 6.0 9.0 basic-11.0 12.0 18.0 24.0 36.0 48.0 54.0 station-role non-root bridge cca 75 concatenation infrastructure-client ! interface Dot11Radio0.1 encapsulation dot1Q 1 native no ip route-cache bridge-group 1 bridge-group 1 spanning-disabled ! interface Dot11Radio0.4 encapsulation dot1Q 4 no ip route-cache bridge-group 4 bridge-group 4 spanning-disabled ! interface FastEthernet0 no ip address no ip route-cache full-duplex ! interface FastEthernet0.1 encapsulation dot1Q 1 native no ip route-cache bridge-group 1 bridge-group 1 spanning-disabled ! interface FastEthernet0.4 encapsulation dot1Q 4 no ip route-cache bridge-group 4 bridge-group 4 spanning-disabled ! interface BVI1 ip address 10.0.0.2 255.255.255.240 no ip route-cache !
Transferring Crash file from standby: Login to the Active WLC in HA.
From CLI: (Cisco Controller) >transfer upload datatype crash (Cisco
Controller) >transfer upload filename (Cisco
Controller) >transfer upload mode tftp (Cisco Controller) >transfer
This is the start of a display filter cross reference between Wireshark
and OmniPeek. The 1st installment is a table of advanced filters. More
filters will be added as time allows. It is a living doc, so check back
for changes every so often Please feel f...
I have created a Powershell script to automatically add a Wireless Guest
User on Cisco WLCs. (tested on 2500 Series) The script should be
completely self explanatory. Prerequisites: Powershell SNMP Module
(Install-Module -Name SNMP) SNMP Write Access to y...