We have aironet 1121 AP. with only one SSID and only one WEP key.
We need to have two VLAN and corresponding SSID with seperate WEP key for both.
Existing configuration is as given here. Do we need to configure the switch port as trunk and with the native VLAN as that will be configured on the AP?
Do we need to configure AP - gi0 interface as a trunk? Can we keep the bv1 IP address same and add one more SSID and VLAN so that we will not loss the connectivity of the AP. In this case it is DHCP reservation in our DHCP server.
sh runn Receiving#sh running-config Building configuration...
Current configuration : 1684 bytes ! version 12.3 no service pad service timestamps debug datetime msec service timestamps log datetime msec service password-encryption ! hostname Receiving ! no logging console
! ip subnet-zero ! ip dhcp pool local-default-pool network 10.0.0.0 255.255.255.224 default-router 10.0.0.1 lease 0 0 1 ! ! no aaa new-model ! dot11 ssid RECEIVING authentication open guest-mode ! ! !
! bridge irb ! ! interface Dot11Radio0 no ip address no ip route-cache ! encryption key 1 size 40bit 7 915020363C01 transmit-key encryption mode wep mandatory ! ssid RECEIVING ! speed basic-1.0 2.0 5.5 6.0 9.0 11.0 12.0 18.0 24.0 36.0 48.0 54.0 station-role root access-point payload-encapsulation dot1h bridge-group 1 bridge-group 1 subscriber-loop-control bridge-group 1 block-unknown-source no bridge-group 1 source-learning no bridge-group 1 unicast-flooding bridge-group 1 spanning-disabled ! interface FastEthernet0 no ip address no ip route-cache duplex auto speed auto bridge-group 1 no bridge-group 1 source-learning bridge-group 1 spanning-disabled ! interface BVI1 ip address dhcp client-id FastEthernet0 no ip route-cache ! ip http server no ip http secure-server ip http help-path http://www.cisco.com/warp/public/779/smbiz/prodconfig/help/eag ! snmp-server view dot11view ieee802dot11 included snmp-server community public RW snmp-server chassis-id receiving ! control-plane ! bridge 1 route ip ! ! ! line con 0 line vty 0 4 login local ! end
Transferring Crash file from standby:
Login to the Active WLC in HA.
(Cisco Controller) >transfer upload datatype crash
(Cisco Controller) >transfer upload filename <Desired filename>
(Cisco Controller) >transfer up...
This is the start of a display filter cross reference between Wireshark and OmniPeek.
The 1st installment is a table of advanced filters. More filters will be added as time allows.
It is a living doc, so check back for changes every so often
Please feel ...
I have created a Powershell script to automatically add a Wireless Guest User on Cisco WLCs. (tested on 2500 Series)
The script should be completely self explanatory.
Powershell SNMP Module (Install-Module -Name SNMP)
SNMP Write Access to...